Defining Waterproofing a Basement.

How do waterproofing systems work in the basement and what exactly are they? For answering that question it will help to first take a look at historically conventional basement waterproofing and the way it was supposed to work.

If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens. A big hole in the ground is dug, the footer or foundations are laid, the walls of the basement are built and then the rest of the house follows.

The important point to note is the first one in the list above - that big hole in the ground.

When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. Loose backfill is what is used to fill this void. No matter how well the backfill is compacted, it is still backfill and water seeks the places of little resistance.

This area is going to have water constantly seeping into it. Typical ways of waterproofing a basement utilize water drainage pipes that often become silted. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. The system can overload if the pipes get over-filled and then the pressure of the built up water would be concentrated on the outer basement walls. Water will work its way through even the smallest gaps, even though basement walls are waterproofed in some way.

The problem of this type is not easily rectified. The reason is that the pipes which are supposed to take away the excess water are gradually getting deteriorated and worsen over time.

A huge problem is that often there isn't access to these pipes. In an attempt to keep excess moisture out basement waterproofing also can be put onto the outer walls of the basement. Usually this is called a tanked system.

A better basement waterproofing system, such as the drained cavity basement waterproofing system, works by getting rid of the water pressure on the walls. Water is controlled, collected and allowed to flow through hidden drainage channels either to natural drainage or to a sump pump where the water is removed away from the property.

Waterproofing a basement is when they are installed internally, have easy access ports for removing silt, and can be installed in basements where other methods have failed.

So to summarise, a good basement waterproofing system will:

- usually be a permanent or long-term solution
- stop both ways by which water can enter through the walls and up from the floor
- not disturb landscaping, decks, patios, driveways, etc
- usually be an approved waterproofing method for home loans
- often be substantially cheaper than other waterproofing methods

Choose a reputable basement waterproofer when protecting your home, remember it is economically foolish not to waterproof, because the increased value from waterproofing will definitely exceed the cost of the waterproofing.

In conclusion, you want a basement waterproofing system that will deliver:

- a permanent or long term fix
- stop water through the floor and walls
- not disturb the exterior appearance of your home
- an approved method by home loan lenders
- more affordable than other methods,

You should look at waterproofing not as an expense but as an investment in the value of your home.